|
作者: NTG P5 |
|
did you use black goo to hold down that wood box for your amp? I suspect it would rattle like crazy if u crank up the bass w/out something holding it down~ ^^"
|
Hehe... Cool.... Anyways, I cut out the opening on the wood panel, made a seperate box to hold the AMP (AMP screwed down onto it), and the box itself is glued AND nailed down to the bottom of the wood panel, then the whole thing(panel w/box attached... I measured and precut the panel to the shape of the trunk... But as you can see on the pics above, I left some gap at the end, near back of the rear seatbacks so wires can pass through there) goes right into the trunk... I put some rugs underneath the wood panel as it's not level and rattles when going over bumps.... And I drilled holes on the wood panel and used OEM tight down holes to secure the panel... But right now, I leave the screws off, so it still rattles a bit if I go through rough roads.....
平板模式
